Solid Core Doors

Solid Core Doors can be found on majority of commercial opening as well as most home entryways. They are constructed around a solid piece of base material, or core and may have a variety of different finishes or designs.

It offers many advantages. Their thickness helps to reduce sound transmission betweem rooms, or from outside the home to indoors. The core also provides some insulation which contributes to energy efficiency in homes. Solid core doors are also more secure and difficult to break into. These doors offers enhanced strength and durability to withstand long- term use and high levels of traffic.

Our standard Solid Core Doors are manufactured to meet or exceed the require- ments of NWWDA I.S. 1.2-87 (Solid Core Woods Flush Doors) and AWI Section 1300, Type PC – 7, American Standard for Architectural Flush Doors.

SPECIFICATIONS

Staved Lumber Core Type

1. FACES: Any available veneers of standard commercial thickness, carefully matched for grain and color. Wide variety of wood species, high pressure plastic laminate and hardboard for painted finish is al available.

2. CORES: Glued Kiln Dried Wood Block. Each core are matched to smooth and uniform width and thickness and bonded together with the end joints and other defects.

3. STILES: Kiln Dried Wood, exposed edges are smooth straight cut and free from knots, pitch pockets and other defects.

4. RAILS: Wood species same as used for wood stiles. A. Rails: Min. 1-3/8” (35mm) wide.

5. LIPPING: Hardwood on vertical edge. Wood specifies same as used for wood face veneer.

6. FINISH: Polyurethane varnish or painted finish. ADHESIVES: Standard Used – Type II Water resistant,

When specified – Type I Water Proof.

SIZE: Width up to 4’ (1219mm), Height up to 10’ (3048mm), Thickness 1-3/8” (35mm); 1-9/16” (40mm); 1- 3/4” (44mm).

Staved Lumber Core Type

SPECIFICATIONS

Particle Board Core Type

1. FACES: Any available veneers of standard commercial thickness, carefully matched for grain and color. Wide variety of wood species, high pressure plastic laminate and hardboard for painted finish is al available.

2. CORES: Mat-formed wood particle board meet or exceed the requirements of ANSI A208.1 as described in the NWWDA I.S.1 Standard.

3. STILES: Kiln Dried Wood, exposed edges are smooth straight cut and free from defects. A. Stiles:Min 1” (25.4mm) wide.

4. RAILS: Wood species same as used for wood stiles. A. Rails: Min. 1-1/8” (28.6mm) wide.

5. LIPPING: Hardwood on vertical edge. Wood specifies same as used for wood face veneer.

6. FINISH: Polyurethane varnish or painted finish.

ADHESIVES: Standard Used – Type II Water resistant, When specified – Type I Water Proof.

SIZE: Width up to 4’ (1219mm), Height up to 10’ (3048mm), Thickness 1-3/8” (35mm); 1-9/16” (40mm); 1- 3/4” (44mm).

Particle Board Core Type